10×10 garage door – When your 10×10 garage door opener stops working, simple steps can help solve the problem. Often, performing tasks such as battery replacement or reprogram the remote control 10×10 garage door opener will have your 10×10 garage door working again. Both tasks are easy to complete. In fact, even a beginner can take charge of this project within a couple of hours. Reset opener, Disconnect the 10×10 garage door from the outlet. Wait 1 minute. Connect the 10×10 garage door opener back into the same outlet to reset the sensors.
Replace the battery; Open the battery compartment on the remote control 10×10 garage door. The battery compartment, located on the back of the remote control, simply slips. Remove the old battery. Often used in remote controls for 10×10 garage door, 9 – volt battery snaps into the compartment. Carefully remove the battery connector apart to remove the battery. Insert a new 9 – volt battery, breaking into the connector at the appropriate places. Slide the battery compartment until you hear a click.
12 Photos Gallery of: How To Restore A 10×10 Garage Door Opener
Reprogram the remote control; Open the battery compartment on the remote control 10×10 garage door. The battery compartment, located on the back of the remote control, simply slips. Note binary rocker switches in the battery compartment. Slide the cover of the battery compartment until it clicks into place. Climb the ladder so you can access the garage door on the roof of his garage. Press the “Learn” head drive motor. Button With that button down, press the button on the 10×10 garage door remote. This sets the remote control transmitter so they can operate the door opener.